I have two of this model, a couple very slight differences. Obtained a aftermarket mica chimney, gave the holed one away as seen in one pic that...
The size I need isn't available, you may not be aware. Most other stuff I have surplus. Duane
Out tinkering with one of my AGM 100 lanterns today as this winter I broke the pricker wire on a brand new genny. I had a couple pricker rods and...
I've not seen one in maroon, however, no US stamped on bottom, but a sorta uinform area where some stenciling could have been, can't make...
I notice no chain or wrench on Terry's site for the one "C" shown. I've noticed most entries here only show one photo, hard to see any unique...
This does have the chained fuel cap and wrench that were on the military green model, would have to look more to see if those came on a civilian...
From what I have seen or read, the military version had stenciling on it regarding to only use kerosene/paraffin. Duane
I've done as much as I'm going to do. Just washed off dust, checked fount innards for crud, cleaned the globe. Used some 0000 brass wool to...
Thank you. The globe looked really clean until I fired up the lantern, needs a good washing in my sink. Duane
Got lucky getting this, no stress cracks, even had pressure in the fount when I unscrewed the chained fuel cap to check out the inside. Had not...
I see Amazon has some, I'll keep my old lanterns, lamps. Duane
Success after numerous avenues of what to do and unsuccessful attempts to solder. Finally some silver solder(brazing?) enabled me to tin the...
Got the nuts off, thank you. Press fits, although the longer shaft had splines and the nut from it is loose on my original shaft, so may try...
The lower shaft is original, the knob I need came off the upper shaft which has the nut I need, have done a heat and quench, but have not retried...
Two dozen people looking, no replies. Duane
Happen to have a valve off a stress cracked AGM lantern, shaft has a good knob, will the nuts off both shafts unscrew so I can transplant the good...
I see in the Reference Gallery the bug screen goes under the globe. Duane
I have a couple original, Optimus stove signs in my gear room. Duane
I still have a few of the Butterfly mantles, use on my Inspection lamp. Can't mess them up on it, don't run it much. Duane
Separate names with a comma.
